Industrial and Warehouse Drywall Contractor in St. Louis
Updated: 4 days ago
Industrial and warehouse buildings need less drywall per square foot than an office, but the walls they do need are taller, more exposed to damage and more likely to carry a fire rating. St. Louis Drywall Pros bids metal stud framing and drywall packages for industrial projects across Greater St. Louis, working from the drawings for general contractors, builders and owners.
Where drywall and framing show up in an industrial building
Demising walls between tenants, usually framed to the underside of the roof deck.
Office build-ins: front offices, break rooms, restrooms and conference rooms inside the warehouse shell.
Separation walls between the office area and the warehouse floor.
Shipping offices, dock offices and supervisor stations on the floor.
Enclosures for electrical, IT and mechanical rooms.
Ceilings over the office area, either drywall or acoustical ceiling tile on a grid.
What makes industrial walls different
Height is the first difference. A demising wall in a warehouse can run well over 20 feet. Tall walls need heavier-gauge studs, closer spacing or both, and the stud size is set by the wall height and the deflection limit in the drawings or the stud manufacturer's limiting-height tables. The top of the wall usually needs a deflection track so the roof structure can move without cracking the board.
Fire ratings are the second. Demising walls and occupancy separations are often rated assemblies. A rated wall has to be built as the tested assembly: the listed board type and thickness, the number of layers, the fastener spacing, and firestopping at the head of the wall and at every penetration.
Durability is the third. Walls near forklift traffic, docks and storage take hits. Drawings often call for abuse-resistant or impact-resistant board on the lower part of the wall. The level of finish also changes by side: a warehouse-side wall is commonly fire-taped only, while the office side gets a full paint-ready finish.
What to send for an accurate bid
Architectural drawings with wall types, heights and the partition schedule.
Structural information for the deck height and any bracing requirements.
The finish schedule, including levels of finish and where ceilings go.
Fire-rating and firestopping requirements, with the assembly numbers if they are listed.
Bid date, schedule and site access details such as lift use and working hours.
How the work is sequenced
Framing starts once the slab and roof are in and the layout is confirmed. Electrical, plumbing and low-voltage rough-in follow, then inspections, insulation, board, taping and finishing. On tall walls, lift access and material staging need to be planned with the general contractor so other trades are not blocked.
Industrial drywall and framing bids in St. Louis
We bid industrial and warehouse drywall and framing packages of $20K and up in St. Louis City, St. Louis County and St. Charles County. Send plans for a bid, or read more about our commercial drywall and metal stud framing scope.
Related pages
Commercial drywall installation and finishing · Metal stud framing · Residential drywall packages for builders · Send plans for a bid
Service areas: Chesterfield, Clayton, Creve Coeur, Kirkwood, Ladue, Town and Country, St. Charles, St. Peters, Ballwin, Wildwood. St. Louis County · St. Charles County
Comments